Swirl Marks In Hardwood Floor

Rubio monocoat recommends finishing the hardwood with 120 grit so that is what i did.

Swirl marks in hardwood floor. Sometimes they are only visible with intense light such as under can sometimes called high hat lights or in front of patio doors. The important part is to never skip a grit or a section of the floor during finish sanding. Five ways to reduce edger swirl the worst part about running the edger is the circular scratch marks it leaves behind. Until you apply finish when they stand out like a sore thumb.

Sometimes these scratch marks are difficult to see especially for a first time floor refinisher. If you do not properly clean the hardwood floor before sanding the debris can be pushed around by the buffer creating a dramatic swirl mark or scratch pattern. Everything from basics on running the big machine to detailed buffer techniques and more are in these wood floor sanding articles. The dreaded swirl marks happen when we are buffing.

Check floor restorer dispenser dilution tip for accuracy. From straight lay strip to parquet herringbone and more these articles offer the 411 on wood floor installation. Use and maintain walk off mats. Restorer not properly diluted.

4 the machine is not balanced. Perfectly finishing a hardwood floor without any swirl marks is a challenge. Wood floor sanding wood floor sanding. Walk off mats can capture up to 85 of all dirt debris and moisture that enters a facility.

These marks aren t usually noticeable until. Swirl marks have been a problem in floor coating since polishers were invented. Dust mop the floor thoroughly before and after burnishing. It s also possible for the debris left on the floor to clog the sandpaper which results in inefficient sanding.

The problem is that the previous coat of finish needs to be scratched to help create a mechanical bond so the fresh coat of finish will adhere well. After removing the swirl marks and imperfections sand the entire floor again with 60 80 grit followed by 80 100 120 grit. Swirl marks on a wood floor are a common problem that often occurs as the result of improper sanding techniques or dirt getting under the sandpaper. The difficulty is exacerbated even more with over head pot lights and gloss finishes.